Smart Wireless THUM™ Adapter
The Smart Wireless THUM Adapter is used to wirelessly communicate HART® data acquired from a wired HART device using a self-organizing WirelessHART™ network.
The Smart Wireless THUM Adapter is:
A device you can retrofit on any existing two or four-wire device
Consists of a radio transmitter, receiver, microprocessor and antenna
Allows you to wirelessly transmit HART measurement and diagnostic information that was previously not available
Unlock the Value in Your Existing Field Devices !
Extend predictive intelligence to areas not possible before due to technical or economic reasons
Features & Benefits
An installation-ready solution that provides rich WirelessHART™ data
2- or 4-wire HART devices
No special power requirements
Smart Power loop scavenging
No battery required
Flexibility to meet your most demanding applications
Wireless output with >99% data reliability delivers rich HART data, protected by industry leading security
Gain access to additional HART information, such as diagnostics or multi-variable data
Add wireless to almost any measurement point
WirelessHART capabilities extend the full benefits of PlantWeb® to previously inaccessible locations
Specifications
Functional Specifications | |
Input | Any 2- or 4-wire HART powered device |
Output | WirelessHART |
Humidity Limits | 0–100% relative humidity |
Update Rate | User selectable, 8 sec. to 60 min. |
Physical Specifications | |
Electrical Connections | The THUM Adapter is connected into a powered 4-20 mA loop, powering itself by scavenging power. The THUM Adapter causes a voltage drop across the loop. The drop is linear from 2.25 volts at 3.5 mA to 1.2 volts at 25 mA, but does not effect the 4-20mA signal on the loop. Under fault conditions, the maximum voltage drop is 2.5 volts. |
Power Supply | Minimum load on loop 250 Ohms To maintain normal operating functions of the sub-device, the power in the loop must have at least a 2.5 V margin at a 250 Ohm load |
HART Communicator Connections | Utilize wired device HART connections |
Materials of Construction | |
Enclosure | Housing - Low-copper aluminum Paint - Polyurethane |
Antenna | Poly butadine terephthalate (PBT) ⁄ Polycarbonate (PC) integrated omnidirectional antenna |
Weight | 0.65 lbs (0.29 kg) |
Enclosure Ratings | Housing option code D is NEMA 4X, and IP66. |
Mounting | The THUM Adapter may be attached directly to the conduit of any 2- or 4-wire HART 5.0 device |
Performance Specifications | |
ElectroMagnetic Compatibility (EMC) | All Models: Meets all relevant requirements of EN 61326-1 (2006) when installed with shielded wiring. The sub-device must also use shielded wiring for installation. |
Vibration Effect | Output unaffected when tested per the requirements of IEC60770-1 field with general application or pipeline with low vibration level (10-60 Hz 0.15 mm displacement peak amplitude ⁄ 60-500 Hz 2g). When the THUM Adapter is used on wired devices that are subject to vibration levels greater than 2g, it is recommended that the THUM Adapter be remotely mounted. |
Temperature Limits | Operating Limit: -40 to 185 °F (-40 to 85 °C) |
Noise level | To ensure proper THUM adapter performance loop must conform with HART requirements for wired communication |
Output Specifications | |
The THUM Adapter allows WirelessHART™ communication between the HART device it is connected to and the Smart Wireless Gateway. |
Applications
Gain Access to Advanced Instrument Diagnostics